How to make your own stage stand for a show.
This one’s pretty simple.
You need two things.
A set of stage stands, a piece of plywood and some duct tape.
We used the “Stages and Stand” video game, which can be purchased on the Nintendo eShop.
You’ll need to buy a couple of sets of stage stand stands for $2.99 each.
The cost includes two set of four-foot PVC pipes, one for each of the three stage stands you need to build.
You can buy the PVC pipe set at Home Depot for $12.99.
The pipe sets can be ordered online from Amazon for $14.99 and $17.99 respectively.
You can also buy PVC pipe sets at craft stores like Lowe’s and Home Depot.
For the PVC pipes you need, you’ll need two lengths of PVC pipe, four feet long, two feet wide and six inches high.
The PVC pipe pieces are about 10 inches long, or about the length of a sheet of paper.
Cut the pieces into lengths that will fit into the PVC stand you want to build for your stage.
You may want to cut them into different lengths for different areas of your stage or for different parts of your show.
To start, cut a circle on each end of each piece of PVC to make a point, and then line the PVC tube with the PVC.
Next, fold the two sides of the PVC so they form a straight line.
You want the end of the tube to be on one side of the stage.
The middle of the pipe should be flush with the stage’s edge.
You’ll want to use two lengths (about four feet each) of PVC and one piece of duct tape to form a triangle.
Cut each triangle into three pieces about 6 inches apart.
The length of each PVC pipe is the same as the PVC tubes.
The tape you cut should be about half the length.
To help your work easier, you can cut the tape at different lengths so you can see the lengths when you’re done.
Now you need a set of ducts to connect the PVC to the PVC tubing.
Cut two lengths out of each of your two pieces of PVC.
You will need to attach each of them to the pipe, which you will then attach to the middle piece of the tubing.
The two pieces should be attached at about the same angle.
To attach the two pieces, place the middle of one piece on the middle pieces of the two PVC pipes.
Put the middle one of the tubes into one of them.
Now attach the third piece of tubing to the tube, and attach it to the fourth piece of pipe.
You’re done!
You can now turn the stage on and off, or if you prefer, switch to the alternate mode and play the video game.
If you’ve made the right measurements, you should be able to walk around the stage without it feeling too crowded.
If your stage doesn’t feel too crowded, you may need to re-attach the PVC piping.
The video game will tell you how long to do this.